test solution
英 [test səˈluːʃn]
美 [test səˈluːʃn]
网络 检测溶液; 测试方案; 试液; 供试品溶液; 测试的全方案的解决
双语例句
- The UTC is also a Web-based test solution.
UTC同样是一个基于Web的测试方案。 - Proceed as directed in the Optical Isomer, the retention time of the major peak of the test solution corresponds to that of the reference solution of Levofloxacin.
照光学异构体检查项下方法试验，供试品溶液主峰的保留时间应与对照品溶液左氧氟沙星峰的保留时间一致。 - Dissolve a portion of the substance under examination in the designated Medium to obtain a test solution having the concentration specified in the monograph for Solution.
将一份该供试物质溶于指定的媒介中，以得到供试溶液，该供试溶液的浓度是在该专论中溶液项下所规定的浓度。 - Causes analysis of high solubility of TAT skin test solution and the countermeasures
TAT皮试液溶度过高的原因分析与对策 - MTT Study on the Response of Human Leukemic Cell to Traditional Chinese Recipes of Huangqi Improvement of test solution preparation for the assay of astragaloside ⅳ from Radix Astragali and its preparations
噻唑蓝法检测中药黄芪等复方制剂对人白血病细胞的影响 - Reference solution ( standard). Prepare as described for the test solution, using the prescribed volume of lead standard solution ( 10 ppm Pb) R instead of the substance to be examined.
标准对照溶液：制备方法同供试品溶液，使用规定体积的标准铅溶液（10ppmPb）替代供试品进行试验。 - Synthetic Instrument is a modular H/ W and S/ W test solution supported by the US DoD as part of its NxTest automatic test system plan.
综合仪器是美国国防部支持的，作为新一代自动测试系统计划的，模块式硬件和软件测试解决方案。 - The results indicated that absorbances of determined element were markedly increased by adding suitable amount of hydrochloric acid into the test solution.
试验表明，加入适量盐酸可显著提高被测元素的吸光度。 - Clinical research on the skin test solution concentration affected by the cephalosporin solution value growth after dissolved
头孢菌素溶解后液量变化对皮试液浓度影响的研究 - Record and compare the spectra concomitantly obtained for the test solution and the Standard solution.
记录并比较伴随地得到的供试溶液和标准溶液的光谱。 - Comparative Analysis on Different Temperature and Humidity Auto-control Equipment of Bulk Curing Barn This represents the ratio of relative humidity of the air over a test solution compared with that of distilled water.
密集烤房温湿度自控设备应用对比分析它代表一个溶液周围的空气相对湿度与蒸发纯水的空气相对湿度的比值。 - Determine the concentration of acetate in the test solution using the calibration curve generated by the average of the readings obtained with the reference solutions.
由对照溶液的平均读数得到校正曲线，用该校正曲线测定供试液中醋酸盐的浓度。 - Using the formula supplied with the standard absorption curve, determine the amount of sulphur dioxide in the test solution from the absorbance measured.
用规范消光曲线供给的公式，从丈量的接收率来测定测试溶液中二氧化硫的量。 - Place one end of the paper in the test solution and the other on the sheet of glass so that the complete insert may be place upon it.
将滤纸的一端放在测试溶液中，另一端复盖放置在玻璃板上的插入物上。 - In view of this, the test solution method can be used for solving the more difficult problems of the static electricity.
由此引入尝试解的解题方法，以解决比较复杂的静电学问题，提高学生分析问题、解决问题的能力。 - Methods: By adding dissolution enhance to make test solution to be homogeneous.
方法：采用加入增溶剂，使供试液成为均匀的乳化状态。 - Application of the Test Solution to Static Electricity
尝试解法在静电学中的应用 - The transient response of iodide ion-selective electrode ( ISE) was studied by means of activity step method switching different concentrations of I-test solution one after another.
用相继切换不同浓度I-试液的活度阶梯法研究了碘化银基离子选择电极（I-ISE）的瞬时响应。 - As the silica gel can deepen the color of the test solution, the optical density is increased.
由于硅胶能加深试验溶液的颜色，引起光密度增加。 - Choice of emulsifier, elimination of chemical interference and preparation of blank solution were studied. A Principle and method of preparing blank solution having the same viscosity with test solution has been examined.
对乳化剂的选择、化学干扰的消除及空白溶液的配制进行了考察，提出了配制与试液粘度相同的空白溶液的原理及方法。 - The stabilization time of suspension, amount of hydrochloric acid solution ( 1+ 1), identity of viscosity for test solution and its blank solution, background absorption interference were studied.
对样品悬浮液稳定时间、盐酸溶液（1+1）用量、试液与空白溶液粘度的一致性、背景吸收干扰进行了考察。 - The dissolving condition of sample, ionization interference, identity of viscosity for test solution and its blank solution, detection limit were studied.
对样品溶解条件、电离干扰、试液与空白溶液粘度一致性进行了考察。 - Identity of viscosity for test solution and its blank solution, and the effect of medium and detection limit were studied.
对介质影响、试液与空白溶液粘度一致性及检出限进行了考察。 - The procedures and the chemical control means of this rust-preventing laying-up method are described. Through dropping test on antirusting property with acidic bluestone test solution, the rust-resisting effect of the method is analyzed by use of surface techniques.
介绍了该防锈保养方法的实施工艺和化学调控手段，通过酸性硫酸铜试液点滴耐锈蚀性能试验，并采用表面技术方法，分析了该防锈保养方法的防锈效果。 - We summarize the scan path solution, the built-in self test solution and the boundary scan solution of design for testability, analyse and compare the character and application strategy of these solutions.
综述了可测性设计方案扫描通路法、内建自测试法和边界扫描法，并分析比较了这几种设计方案各自的特点及应用策略。 - However, this new software development method is completely different from traditional ones, so the test solution and model in traditional software development methods can not meet the Scrum method.
但由于这种新兴的软件开发方法完全不同于传统的开发方法，因此在传统开发方法中使用的软件测试方案和模型无法适应Scrum方法。 - Then corresponding analytical software is developed based on the MATLAB language. By comparing the test solution with classically theoretical and numerical solution obtained by the finite element method, the calculating example validates its accuracy and efficiency.
根据所推导的边界元法解析公式，基于MATLAB语言开发了相应的解析软件，并通过算例将软件的解析结果与经典理论和有限元法数值解进行了对比，从而验证了它的正确性。 - This paper also discusses the important role of statistics and quality control in system, how to implement Quick Test solution to probe area.
本文还论述了统计方法和质量控制方法在系统中的作用以及该方案如何在探针测试中应用。 - Finally this paper provides currently defects and challenges which Quick Test solution facing.
最后本文还讨论了目前自动化快速测试方案面临的缺陷和挑战。